The Danchuk Tri-Five Nationals presented by Woody's Hot Rodz

  Home > Suspension > Steering >

Unisteer Manual Rack & Pinion - 1955-57 Chevy

Unisteer Manual Rack & Pinion - 1955-57 Chevy


 
Additional Photos:


UNI-8000230
Our Price: $860.95

Product Code: UNI-8000230




Qty:  
Description
 

Unisteer Manual Rack & Pinions are built using a modified traditional style GM rack & pinion for 1955-57 Chevrolet. The rack is bolted to a 1-piece bracket which mounts where the old steering box and idler arm were mounted on the frame. The rack is machined so that it is more narrow, to match the stock suspension. Black or chrome finish available.

This rack and pinion will save you up to 70lbs! Designed for use on Tri-Fives with a small block motor with headers. (Sanderson & FlowTech are recommended). Other headers may work as well, but may require modifications or a shaft kit with three U-joints. Big block installation are possible, but are more difficult and will require a three U-joint setup, a support bearing and probably header modifications.

This rack has less travel than the old pitman arm, so the arms are necessary to maintain comparable turning radius. Unisteer shaft kits are available for small block cars, which consist of two U-joints, DD shafting and a coupler for aftermarket columns or a bearing to reuse the factory column.

Includes rack & pinion, mounting bracket & hardware, and steering arms. Allows 5" of travel, 2-1/2 turns from lock to lock, 14mm x 1.5 inner thread ends, 16mm DD pinion. Not for street use.

Share your knowledge of this product. Be the first to write a review »